Home
/ Sheet / Hot
Rolled Sheet / Non-Pickled
Temper Rolled / Tolerances
Hot Rolled Sheet
Non-Pickled Temper
Rolled
Tolerances
Camber Tolerances
All hot rolled sheet from any source will exhibit some variation in thickness, width, length, flatness and camber. Tolerances for each of these attributes are given in the Tolerance Tables.
Camber
Tolerances
These tolerances do not apply when
stretcher level standard of flatness is
specified
|
Hot Rolled Carbon and High Strength
Low Alloy Sheet
Cut Lengths Not Resquared,
Including Pickled
Camber is defined as the deviation of a
side edge of hot rolled sheet from a
straight line, in a length of 20 feet
(6.1 m).
|
|
Cut Length, feet (m)
|
Camber tolerances, inch (mm)
|
|
To 4 (1.2) incl.
|
1/16
(1.6) |
|
Over 4 (1.2) to 8 (2.4) incl.
|
1/8
(3.2) |
|
Over 8 (2.4) to 12 (3.7) incl.
|
3/16 (4.8)
|
|
Over 12 (3.7) to 14 (4.3) incl.
|
1/4 (6.4)
|
|
Over 14 (4.3) to 16 (4.9) incl.
|
5/16 (8.0)
|
|
Over 16 (4.9) to 18 (5.5) incl.
|
3/8 (9.5)
|
|
Over 18 (5.5) to 20 (6.1) incl.
|
7/16 (11.0)
|
|
Over 20 (6.1) to 30 (9.1) incl.
|
5/8 (16.0)
|
|
Over 30 (9.1) to 40 (12.2) incl.
|
3/4 (19.0)
|
The camber tolerance
for coils is 1/2 inch (12.7 mm) in any 20 feet (6.1 m).
Applies only to temper rolled product.
|
|
